![]() |
Re: pic: FRC488 Completed Drive Train
here is a teaser of just our frame!!!!!!!:yikes:
|
Re: 1764 Frame Teaser
Cool design for an Omni drive. Have you done any programming for it yet?
Joey |
Re: pic: FRC488 Completed Drive Train
hollistic drive looks great! :D
|
Re: 1764 Frame Teaser
Looks good. Check your bumpers - there was a post in Q&A just yesterday I believe that prohibits mitered pool noodles into the corners, even if the wood doesn't extend into the corners.
|
Re: 1764 Frame Teaser
Yes there is programming for the prototype that is setup the same. And can you tell us where you found that information for the bumper?
|
Re: 1764 Frame Teaser
very cool, I am assuming the electronics are mounted above this piece?? if not thats a pretty tight squeeze lol!
looks sweet though!! |
Re: 1764 Frame Teaser
Quote:
Joey |
Re: 1764 Frame Teaser
there will be a plate on the underneath the frame (beneath the motors) and on the battery plate
|
Re: 1764 Frame Teaser
we don't need help with programming but thank you and yes it does go in every direction.
|
Re: 1764 Frame Teaser
Quote:
|
Re: 1764 Frame Teaser
If you're interested....see video below.
In the video our robot is only doing a third of what it's capable of. The first half is on ceramic tile and then the second half shows the capabilities on carpet. Our programmer estimates the top speed to reach 15ft/s. Direct link to video: http://www.liberty.k12.mo.us/hs/libe...ive%20test.wmv Our website: http://www.liberty.k12.mo.us/hs/libertyrobotics/ |
Re: 1764 Frame Teaser
Quote:
Joey |
Re: 1764 Frame Teaser
click on our website link and then go to 2008 competition and watch the video from there. If it doesn't come up you have to run activex control to see (we have to here).
|
Re: 1764 Frame Teaser
Actually the direct link was just entered improperly. If you do want to directly download and view the file, try this one:
http://www.liberty.k12.mo.us/hs/libe...Drive test.wmv Otherwise you can go their website as described above to view it embedded in the page. |
Re: 1764 Frame Teaser
thank you for doing that!
|
| All times are GMT -5. The time now is 22:13. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright © Chief Delphi