Chief Delphi - In need of sprockets

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- General Forum (http://www.chiefdelphi.com/forums/forumdisplay.php?f=16)

- - In need of sprockets (http://www.chiefdelphi.com/forums/showthread.php?t=62829)

Armando Gonzalez

29-01-2008 21:34

In need of sprockets

Does anyone know where to find sprockets for the taigen (van door) motor?

thefro526

29-01-2008 21:43

Re: In need of sprockets

We bought sprockets made for a three eights (3/8") shaft and drilled them out to 11mm or so and then screwed them onto the shaft.

Armando Gonzalez

29-01-2008 21:59

Re: In need of sprockets

Quote:

Originally Posted by thefro526 (Post 688397)

We bought sprockets made for a three eights (3/8") shaft and drilled them out to 11mm or so and then screwed them onto the shaft.

where?

thefro526

29-01-2008 22:11

Re: In need of sprockets

mcmaster.com or grainger.com has them as for the drill bit i just got a metric caliper measure the shaft to be about 11mm or so and them found a drill bit that was close to 11mm

Armando Gonzalez

29-01-2008 22:18

Re: In need of sprockets

Quote:

Originally Posted by thefro526 (Post 688429)

mcmaster.com or grainger.com has them as for the drill bit i just got a metric caliper measure the shaft to be about 11mm or so and them found a drill bit that was close to 11mm

thanks

thefro526

29-01-2008 22:25

Re: In need of sprockets

PM if you need more help with the sprocket

All times are GMT -5. The time now is 04:26.