Bumper dimensions. IMPORTANT!!
 

According to the bumper rules it says that the bumpers must cover 2/3 of the perimeter of the robot. Would that be the perimeter of the bottom of the chassis or the max length and width of the chassis?

Re: Bumper dimensions. IMPORTANT!!
 

My opinion is that it means 2/3 of the perimeter of the robot within the bumper zone.

Warning: My opinion is worthless at inspection.

Don

Re: Bumper dimensions. IMPORTANT!!
 

it's max length and width

look at fig. 8-2 (page 11, Sec. 8) in the rule book

BBBBBBB
B[&&&]B
B[&&&]B
B[&&&]B
B[&&&]B

(B=Bumper)

I agree with the last person about the inspection

Good Luck

Re: Bumper dimensions. IMPORTANT!!
 

yea cause our top half of the robot extends about 4 more inches then our frame so i was not sure if the 2/3 applied to the frame in the bumper zone or the entire robot.

Re: Bumper dimensions. IMPORTANT!!
 

It's the "exterior perimeter".

I'd interpret that to be something like perimeter of the bounding box (if we're talking about rectangular robots). If the shape is more complex, I would wonder whether the intent is for the rule to apply to the convex hull shape that encloses the robot, or if there's some other criterion for defining what's an exterior feature, and what's an interior feature (and not included in the perimeter). I'd be inclined to accept any good-faith attempt that satisfies the 2/3 stipulation by some obvious metric.

Re: Bumper dimensions. IMPORTANT!!
 

You'd certainly have a problem if you had a C shaped robot... if of course it literally required 2/3 of perimeter in that sense.

BBBBBBBB
BOOOOOB
BOBBBBOB
BOB BOB
BOB BOB
BBB BBB

Re: Bumper dimensions. IMPORTANT!!
 

Which it doesn't.