Making your own plywood for the bumpers
 

Do you think we you can manufacturer our own plywood for the bumpers or is there a rule you must buy the plywood already made?:confused:

Re: Making your own plywood for the bumpers
 

theres no rule that i know of, just that the plywood must be 1/2" thick (or is it 5/8"?) it's in the robot part of the manuual, but as far as my judgement goes, you should be fine with making your own.

Re: Making your own plywood for the bumpers
 

I'm trying to say this as nicely as possible. Absolutely nothing in the above answer was correct. Plywood must be 3/4". And the GDC has said you cannot make your own: http://forums.usfirst.org/showthread...hlight=plywood

Re: Making your own plywood for the bumpers
 

I wish that <R08> specified the word "commercial", rather than having to deal with it in the Q&A. After all, there was nothing in the rules themselves that would have led a team to think that making their own plywood was illegal.

Re: Making your own plywood for the bumpers
 

Wow. You must have some folks on the team you want to punish.:ahh: