[FTC]: Problem with two controller setup in Labview
 

Greetings,
Team 35 is waist deep into our build and things have been going rather smoothly until we tried to put the drivebase control on one logitech controller and the arm control on the second. As soon as we put a second controller VI into labview and upload it into the brick, we get no response from the robot at all. Both controllers are dead. Has anyone else run into this problem?

Re: [FTC]: Problem with two controller setup in Labview
 

You have to download the two controller update for labview on the NI site.
http://zone.ni.com/devzone/cda/tut/p/id/7956
click the Dual Controller update.

Re: [FTC]: Problem with two controller setup in Labview
 

Yep, we just found that on the website. thanks!