cRIO Not Running Program
 

I should start off by saying we are running Labview. We have written a simple tank drive program to test with. Our problem is, the only way to run the program, is to have a laptop connected to the driver station and click, "run" in the main .vi window. Otherwise the program never runs, it just sits there. Is there a way to have the program run without having to have a laptop connected?

Thanks

Ron
Team 935 Captain

Re: cRIO Not Running Program
 

Did you set it to run at startup when you deployed the standalone application?

Full instructions for deploying a standalone application can be found on Page 14 of this document:
http://decibel.ni.com/content/servle..._Framework.pdf

Re: cRIO Not Running Program
 

open a FRC project in labVIEW.
Right click on "build specifications"
select "stand alone application"

Re: cRIO Not Running Program
 

Yep, that is it. We did have our real-time application set to run at startup, but we were not waiting long enough. We had to set it as startup, and let the computer sit for a while (several minutes) and let it reboot. Note: do not click, "stop waiting and disconnect", just WAIT.

Re: cRIO Not Running Program
 

How long are we supposed to wait? I've followed the instructions listed above, but when I "Ran as Startup" it gave me the box of "Waiting for real-time target" and that was 30 minutes ago. What am I missing?:(

Re: cRIO Not Running Program
 

Never mind. I must have missed the part where we were supposed to change the IP in the 'Target' line of the Project Explore window. Oops! :o