Anyone Into Designing Paintball Marker Parts?
 

Just thought I'd ask. I'm new to this forum, but I frequent other forums quite a bit. I'm in to cars and paintball, and they take up a lot of my time. Sometimes I like to draft potential products or ideas that I can have made or tested. Here are a few examples. Feel free to comment or add your own!

Moderators and concerned members or whatnot, just remember that these are just CAD drafts of paintball markers for recreation. Just thought I'd add that in case someone thought they were inappropriate.

---------------------------------------------------------------------------

This is a little draft I did one day after watching Stargate SG-1 and seeing
the FN-P90's that they use. I combined the shape of a P90 with that of a Tippmann A-5 paintball marker. And the beast was born.










This next draft came after I wanted to see what a the firing operation of a 98 Custom with E-Bolt would look like with eyes (proxy sensors).

Re: Anyone Into Designing Paintball Marker Parts?
 

This next one is from a mini ram used to activate a valve on a 98 Custom E-Bolt configuration. It's about 50% smaller than the stock ram. Custom designed. The last picture shows the finished product.









Last one I have is of a scythe trigger that was fabricated for the same 98 Custom E-Bolt setup from conception to production. Currently there are 8 made.

Re: Anyone Into Designing Paintball Marker Parts?
 

Re: Anyone Into Designing Paintball Marker Parts?
 

All the "black" finish is black anodizing.


Lastly I have a battery tray that was drafted and later made for my brother's 1997 Mitsubishi Eclipse GSX. Made in Solidworks.