Blarg!
 

OK so I have been working on this project in lab view for several hours now all to know avail. I am trying to write a program so that when the trigger (button 1) is pushed, the robot will activate a spike in a forward or reverse direction. The spikes are wired to the digital side car under PWM 3 which is then connected into slot 4. did I wire the spike wrong? should it be wired into a relay connection? Any help would be necessary.

Re: Blarg!
 

Yup, the spikes should be wired to the relay ports.

Only servos and speed controllers connect to the PWM ports.

Re: Blarg!
 

would you might now how I would go about programming that in lab view? I already know that you must use the relay vi's but how might I tie that to a button? sorry but this is my first year coding

Re: Blarg!
 

I loveeee Blargity Blarg-Tucker! :D