Chief Delphi - Drive Station Holder

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- FRC Control System (http://www.chiefdelphi.com/forums/forumdisplay.php?f=176)

- - Drive Station Holder - What do you use? (http://www.chiefdelphi.com/forums/showthread.php?t=71738)

Tanner

09-01-2009 23:02

Drive Station Holder - What do you use?

2 Attachment(s)

Hi all,

Not sure if anyone else noticed the driver station looks a bit better when it is angled up rather than just laying flat on a a table. When we were doing the bench test, I noticed that the station fit nicely into this little piece of plastic that was laying around dad's office. No idea what it is, but it fits QUITE nicely.

What do you use?

-Tanner

whitetiger0990

10-01-2009 00:35

Re: Drive Station Holder - What do you use?

I think we are just going to velcro it down flat. I don't see why we need to angle it, you can't change the data displayed on the screen. Need to figure the best place to put feedback LEDs. Drivers tend to not look down.

All times are GMT -5. The time now is 22:59.