Help on Labview beginners
 

I've seen 3 videos on how to use some labview, but is there anywhere else where you can find some video tutorials on how to use LabView.

Setting relays and such with joysticks and buttons is even a problem to an 18 year old that's used to using Easy C :(

Any help is appreciated. :)

Re: Help on Labview beginners
 

Try this website.

http://decibel.ni.com/content/docs/DOC-2511

Its from the National Instruments website. Just follow along and you should get it. It has helped me to understand labview. I was used to programing on MPLab and have never seen labview before this season.

Re: Help on Labview beginners
 

This series is also very good.
http://www.lvmastery.com/tipjar2008

Re: Help on Labview beginners
 

Getting Started with NI LabVIEW Student Training
http://zone.ni.com/devzone/cda/tut/p/id/7466

LabVIEW for Dummiees
http://www.iit.edu/~labview/Dummies.html

LabVIEW Style Checklist
http://zone.ni.com/reference/en-XX/h...pts/checklist/

LabVIEW Graphical Programming Course
http://cnx.org/content/col10241/latest

Getting Started Programming with FRC Hardware
http://decibel.ni.com/content/docs/DOC-2511

LabVIEW Robotics Programming Guide for the FIRST Robotics Competition
http://decibel.ni.com/content/docs/DOC-2631

Tip Jar #5 - LabVIEW Primer for FIRST Robotics Competitors
http://www.lvmastery.com/tipjar2008-12-03
Tip Jar #6 - LabVIEW Primer Part II for FIRST Robotics Competitors
http://www.lvmastery.com/TipJar2008-12-04
Tip Jar #7 - Video from Live LabVIEW Session for FRC Competitors in Toronto
http://www.lvmastery.com/TipJar2008-12-12
Tip Jar #8 - Autonomous Mode in the FRC Basic Robot Framework
http://www.lvmastery.com/TipJar2009-01-02
Tip Jar #9 - Making Friends with the FRC Advanced Robot Framework
http://www.lvmastery.com/tipjar2009-01-05


CompactRIO cRIO-FRC Operating Instructions and Specifications
http://decibel.ni.com/content/docs/DOC-2632






hope it helps. a mentor posted this on my teams forums

Re: Help on Labview beginners
 

I didn't want to start a new thread just to ask a question, so I will recycle this one since it's generic title:

Is there anything close to a timer, that I can reset and read, etc?
I'd like to make a case loop which runs continuously for 1 second when a boolean control is pressed, but I don't seem to find any suitable timing funcion. Wait doesn't apply, and I don't understand very well the rest of them.

If anyone could give me a hint, I'd appreciate.

Re: Help on Labview beginners
 

If you read the Tick Count when the button is pressed, then each iteration, you can decide to continue until current minus button is greater than 1000 ms.

Greg McKaskle