Chief Delphi - Festo Solenoid Doesn't Work

Page 2 of 2

Show 100 post(s) from this thread on one page

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Pneumatics (http://www.chiefdelphi.com/forums/forumdisplay.php?f=54)

- - Festo Solenoid Doesn't Work (http://www.chiefdelphi.com/forums/showthread.php?t=72278)

Dr. Manhattan

10-02-2009 17:46

Re: Festo Solenoid Doesn't Work

Quote:

Originally Posted by camtunkpa (Post 817784)

I will second the pins 1&3 connection. 222 had the same exact problem on both of our festo valves.

Just to clarify, negative goes into 1, and the positive into 3?

camtunkpa

11-02-2009 16:42

Re: Festo Solenoid Doesn't Work

I don't remember what the polarity is, but I do remember pin 1 is correct as shown on the connection diagram from festo. We just had to move the wire from pin 2 to pin three

roborat

11-02-2009 17:09

Re: Festo Solenoid Doesn't Work

My Festo would not work so i just switched to a SMC single solenoid and it works fine. I am going to change the wiring on the festo to see it that was the problem.

Dr. Manhattan

11-02-2009 18:26

Re: Festo Solenoid Doesn't Work

Team 2521 can also confirm that switching to 1 & 3 worked. One of them didn't, but we assume that that's because it was DOA.

nevereverregret

11-02-2009 20:20

Re: Festo Solenoid Doesn't Work

our festo valves wouldnt work at all... we gave up and are using last years and now they wont work either

Dr. Manhattan

11-02-2009 20:33

Re: Festo Solenoid Doesn't Work

Are you getting any sort of LED response on the breakout or festo itself? Also, make sure that you're breakout is plugged into cRIO module 8 in NI 9472 or it won't work. If you have any more questions feel free to PM me.

All times are GMT -5. The time now is 16:34.

Page 2 of 2

Show 100 post(s) from this thread on one page