Programming into Servo??
 

We have been having trouble programming servo to our joystick:confused: . We have two joysticks and the first one is under "USB1" and is connected to two "joystick: get axis" and one of them is "axis 1" and the other is "axis 2" and the "joystick: get axis" is connected to a "drive: arcade drive". The second joystick we have connected to one "joystick: get axis" and it is an "axis 1" and that is connected to a different "drive: arcade drive" which is connected to an "error in (no error)" box. Our "servo: open box" is on "slot 4" and "pwm 3" and is connected to "servo: get angle" and that has an angle box connected to it and the "servo: get angle" is connected to "servo: set angle". We are in labview. We can't get the "servo: set angle" to connect to anything. We did have it connected to a knob but we deleted it. If you can help us that'd be great, or if you know the number for the 24 hour help line that can assist us that'd be even better. Thankyou!

Re: Programming into Servo??
 

Could you post a picture or something? I think I might be able to help but I'm not good with written descriptions. I worked with programming a servo to run off of our joystick, but we only used one. I think that your problem might be using 2 joysticks with arcade drive (are you trying to do tank drive?), but I'm not sure.