Chief Delphi - pic: Low brace for drive

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Extra Discussion (http://www.chiefdelphi.com/forums/forumdisplay.php?f=68)

- - pic: Low brace for drive (http://www.chiefdelphi.com/forums/showthread.php?t=72817)

RMS11

24-01-2009 09:46

pic: Low brace for drive

loading photo ...

5n1p3r

27-01-2009 21:04

Re: pic: Low brace for drive

WOAH:yikes: :eek: Thats like a lowrider squared rofl, ours is a a quarter inch too

daltore

27-01-2009 21:59

Re: pic: Low brace for drive

I'd be really careful with that. If you get hit and it bends at all and hits the floor, you could be penalized by adding traction against the hit (the aluminum would slow down the robot in the direction of the hit).

Hal9000

27-01-2009 22:28

Re: pic: Low brace for drive

That could creat dragging problems if there are any parts on the floor or if the floor is warped

RMS11

27-01-2009 22:53

Re: pic: Low brace for drive

Quote:

Originally Posted by Hal9000 (Post 809368)

That could creat dragging problems if there are any parts on the floor or if the floor is warped

Yes, if this seems to be a problem at pre-ship scrimmage then we can replace it with C channel and move it up a bit. I am not worried about it bending, but a warped floor is always a possibility...

Ian G

28-01-2009 00:03

Re: pic: Low brace for drive

Quote:

Originally Posted by daltore (Post 809327)

You can't tell from this picture, but the bar is in the interior of the frame, so it can't be hid directly. So i f that bar bends, added traction will be the least of our problems! :ahh: lol

All times are GMT -5. The time now is 12:34.