Question about Rules regarding the cRIO
 

I was wondering wether its possible to disconnect modules from say slot 2, slot 6 and slot 8 (1 for analog, 1 for DS, 1 for Pneumatics), seal thier connection useing the KOP supplied rubber plugs. Is it possible to pass inspection? assuming i have slot 1 plugged in, and the jumpers on for battery monitoring, and assuming i dont use any other slot than slot 4 so i keep the other modules out of the cRIO... obivously for less weight.

couldnt find any rule aginst it on "The Robot" PDF, so if anyone can point me to a rule that says otherwise, it would be great.

Thanks in advance,
Steampunk 1577 Electronics Crew

Re: Question about Rules regarding the cRIO
 

You might take a look at Update #8. It doesn't say this directly, but it sure implies that you are correct.