Chief Delphi - 2 Motors 1 Jaguar

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Electrical (http://www.chiefdelphi.com/forums/forumdisplay.php?f=53)

- - 2 Motors 1 Jaguar (http://www.chiefdelphi.com/forums/showthread.php?t=74116)

comwiz7

10-02-2009 20:22

2 Motors 1 Jaguar

Is it okay to connect two identical motors to one jaguar?

DiscoDancer

10-02-2009 20:25

Re: 2 Motors 1 Jaguar

No, you can't because its a hazzard
because there are two motors, theres double the current
and it could mess up your electronics

IndySam

10-02-2009 20:43

Re: 2 Motors 1 Jaguar

No

<R48> Each power-regulating device (speed controller or relay module) shall control one and only one electrical load (motor, actuator or compressor).

Al Skierkiewicz

11-02-2009 08:08

Re: 2 Motors 1 Jaguar

However, in another thread, Erik Van Wyk has reported that you can connect two Jaguars or two Victors to the same PWM cable using a "y" adapter cable. That would allow you to control two motors through two controllers with a single control output.

All times are GMT -5. The time now is 10:52.