Programming a boolean switch.
 

We have a basic (Physical) boolean switch that's wired to DIO 2. I'm not completely sure how to wire this in labview, but what I have now is.

1) DIO in (Open)
2) DIO in (Get)
3) The get connector is wired to a case statement

Is this correct? Or is there another way to program it?

Re: Programming a boolean switch.
 

That's what I usually do.

Re: Programming a boolean switch.
 

I probably should have specified that it isn't working :P.

Re: Programming a boolean switch.
 

Hardware problem :)

Re: Programming a boolean switch.
 

Yeah, that's what I figured it is, we're rewiring the switch now. (As per your instructions in the other thread.) Hopefully it'll work. Thanks for all the help. :)