No Code = :(
 

I just updated with the new firmware and crio image. Everything was fine up until i tried to load the old programming i had done with the old firmware and now no matter how i deploy build or run the code it says no code... this is freaking me out cause i only have 1 week to get all the bugs out of the code before competition. any ideas?

Re: No Code = :(
 

another thing.. it says access denied: this target is in use by another project or host computer.

i know i have to undeploy the program but how..? i've already tried the "unset as start up" as stated in the framework manual but it doesn't work.

Re: No Code = :(
 

This may sound really dumb, but are you letting it download 100%, or are you pressing a button halfway throughish the download?

also, target in use by another computer usually means you stop the program on the other computer or reboot the rio.

Re: No Code = :(
 

ok... i got the access denied thing resolved and now it is letting me run the code but it doesnt do anything and it still says no code..

Re: No Code = :(
 

What version of LabVIEW did you have before the update? If it was old enough, you may have to recreate the framework and port your code.

Re: No Code = :(
 

I think i just figured it out... if i am right i make such a stupid mistake i forgot to put the new update on the programming computer... i did the reimage with my personal computer and i forgot about the dedicated programming computer. thanks joe for reminding me about the update. its installing as i type this so lets see what happens.


EDIT: That was exactly the problem.... thanks for all your help.