Chief Delphi - pic: FRC-34 2009 Frame Concept (Front View)

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Extra Discussion (http://www.chiefdelphi.com/forums/forumdisplay.php?f=68)

- - pic: FRC-34 2009 Frame Concept (Front View) (http://www.chiefdelphi.com/forums/showthread.php?t=77398)

pic: FRC-34 2009 Frame Concept (Front View)

Re: pic: FRC-34 2009 Frame Concept (Front View)

How Tall off of the table is the top of the frame?

Re: pic: FRC-34 2009 Frame Concept (Front View)

What are you using to support each Module at the bottom?

my team is building a crab drive and we are looking at different ways to support each module......

we're thinking Lazy-susans......

Re: pic: FRC-34 2009 Frame Concept (Front View)

Quote:

Originally Posted by Andrew Schreiber (Post 862002)

Would http://www.chiefdelphi.com/media/photos/33335 answer your question?

Kind-of...:o

well we're planning on doing one of these(basically the limit of our machining capabilities)
http://www.chiefdelphi.com/media/photos/32459

we're just trying to figure out how to support it from both ends easily....

so i was thinking a 2 large Lazy-Susan's that we can bolt a plate onto each side, so we can then attach the module itself at the top and bottom, As well at attach it to a Kit-Frame(05') without having to modify it too much....