VEX EasyC Pro reading interrupt ports directly
 

Using a VEX and EasyC Pro I want to read the interrupt ports directly just like a regular digital port.

I have been using interruptwatcher that is good for watchng a state change, but I want to read the port directly to see what the current state is.

Nothing is built into EasyCPro to do that but wondered if there was something in code you could do.

Thanks

Re: VEX EasyC Pro reading interrupt ports directly
 

Doug,
I can't answer your question but you may want to repost directly on VEX robotics forum for answer.

Re: VEX EasyC Pro reading interrupt ports directly
 

Instead of immediately reposting, search first. I remember that this topic came up recently in that forum. I vaguely remember the exchange and I think that what you want to do is possible.