Re: Code not loading properly
 

We can now connect via Remote System but still get "No Robot Code"

Re: Code not loading properly
 

did you do a (right click on project)>Run Kernel task...?

Re: Code not loading properly
 

When you reimage the cRIO, make sure you select the type of software you are using. We were trying to help another team that had imaged their cRIO for LabVIEW. When we downloaded C++ code, everything looked good but we got the No Code message.

Re: Code not loading properly
 

We're use Labview. Every time we develop new code and try to deploy it or connect to the cRIO, there a error that says the vi's in the start up application will not open and will remain closed if you continue to apply and deploy. I found out the by using the 'cRIO Imaging Tool' and hitting 'Format controler', the pproblem is removed and we can deploy the code and run a drive test. But when we switch users back into the developer the same problem occurs and the cRIO needs to be re-imaged again. Running the 'cRIO imaging tool' with the format controler takes about seven minutes to finish; and ontop of that we still need to deploy and build the code which take another five to seven minutes. We seem to be spending a lot of time re-reimaging the cRIO to fix our problem. How do we fix it?:confused:

Re: Code not loading properly
 

Please don't post the same question in multiple places. It won't get you answers any faster. (The C++ subforum is not a good place for a LabVIEW discussion anyway.)