![]() |
Programming the PSoC
Does anyone have any idea how to program the PSoC from the kit of parts. Or how to use it? If anyone has any information on the matter, please post.
|
Re: Programming the PSoC
Quote:
It can be used on the classmate Driver Station to provide access to custom I/O such as buttons, knobs, LEDs, etc on your driver console. You must use the official provided firmware if you wish to use it this way. It can also be used on the robot in any custom way you choose (i.e. a sensor interface for any special sensors you decide to use). You must make your own design and firmware for it in this use case. The easiest way to interface it with the cRIO is probably with I2C, though there are many other ways that are possible. |
Re: Programming the PSoC
custom firmware???? Umm, can you put that in plain english?
|
Re: Programming the PSoC
The PSoC board has a processor and some reconfigurable mixed-signal logic fabric on board. Basically, you would need to write your own code to run on the board if you use it on the robot.
The expected use case for 99% of teams is that it will be used with the driver station to wire up buttons. |
Re: Programming the PSoC
Quote:
|
Re: Programming the PSoC
Quote:
|
Re: Programming the PSoC
Quote:
|
Re: Programming the PSoC
Quote:
|
Re: Programming the PSoC
Didn't I say all this yesterday? ...in the second post?
|
Re: Programming the PSoC
BTW, how would I connect it via I2C?
|
Re: Programming the PSoC
Quote:
|
Re: Programming the PSoC
Wha????
:confused: :confused: :confused: |
Re: Programming the PSoC
If you didn't understand any of that, you probably shouldn't try anything so advanced just yet. You can work on programming the board in the off-season if you like.
|
Re: Programming the PSoC
Thanks for the encouragement. |(
|
Re: Programming the PSoC
Hi -
From the past few posts, I am under the impression that I do not need to connect or do anything with the PSoC board if we choose not to use it for any of the above things. Is that correct? In other words, I am asking if it is required to be used and connected to the Classmate PC. I read the control system documentation and did not see anywhere that it said that I needed it. Please tell me if my interpretation of these things are correct. Thanks. |
| All times are GMT -5. The time now is 19:56. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright © Chief Delphi