configure wireless router
 

i am trying to configure the wireless router,wrt160n, i am following the FRC 2010 control manual step by step, the bridge configures just fine, but when i get to page 52, the picture in the manual show the start IP address as 10.0.0.1, however mine shows the default 192.168.1.1 i cannot get it to change so i can put in my address for our team, likewise the ipaddress range is only the default.

please help

Re: configure wireless router
 

While I haven't configured a WRT160N, I believe if you put in the IP address on top, and set the start IP address to 10, when you save the settings and reboot, everything will be correct afterwards.