Chief Delphi - cRio and code dont work!

Page 2 of 2

Show 100 post(s) from this thread on one page

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Programming (http://www.chiefdelphi.com/forums/forumdisplay.php?f=51)

- - cRio and code dont work! (http://www.chiefdelphi.com/forums/showthread.php?t=81001)

deeek

25-01-2010 11:46

Re: cRio and code dont work!

Quote:

Originally Posted by Alan Anderson (Post 906064)

If you're using a Victor speed controller, it takes some practice and experience to know when the PWM connector is seated properly. Be prepared to have to fiddle with it for a while.

Thank you all for your support!

We are actually using Jaguar speed controllers. Are there any magic tricks for these? ;)

Also, we will check out the pins on our modules as well. Thanks for all of the great ideas.

tomgee4me

25-01-2010 12:08

Re: cRio and code dont work!

Is your emergency stop button plugged into your PC? Nothing will run if it's not. There is a way to bypass the stop button also.

tomgee4me

25-01-2010 12:37

Re: cRio and code dont work!

Oops, you already said you did that. Sorry.

deeek

25-01-2010 14:23

Re: cRio and code dont work!

Quote:

Originally Posted by tomgee4me (Post 906515)

Oops, you already said you did that. Sorry.

Yup, emergency stop is plugged in, as are two joysticks. Also, we can see activity on module 8 when we use the joysticks. I think we will just have to make sure the cables are in good condition and check the digital sidecard. Thanks again for your help.

All times are GMT -5. The time now is 21:24.

Page 2 of 2

Show 100 post(s) from this thread on one page