Slow update speed updating Jaguars
 

It's taking about 1/2hr to update a jaguar that seems off, any ideas?

Re: Slow update speed updating Jaguars
 

What is your setup? For example, how are you Jaguars connected to the update computer, how are you powering them, etc?

Are you using bdc-comm in the command line or GUI?

List the steps you are taking.

-David

Re: Slow update speed updating Jaguars
 

Figured it out, the RJ-12 was crimped upside down. The funny thing is while BDC-Comm was acting odd it looked like it was working. It wasn't until I re-crimped the connector I found out how it should work.

Now I just need to get more then one to work at a time. I've set the black jag to ID 5. Then plugged in a Grey Jag w/100ohm 1% terminator and the second Jag LED won't go solid, and BDC-Comm won't detect it.

The configuration is as shown in MDL-BDC24-GSG.pdf, Page 26, Figure 8-1

Re: Slow update speed updating Jaguars
 

I would double check the cable going between the Black Jaguar and the second Jaguar. If the pins don't go 1 -> 1, 2 -> 2, and so on then you won't get communication.

-David

Re: Slow update speed updating Jaguars
 

If I hold the connectors side by side it looks like this.