Chief Delphi

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)
-   Sensors (http://www.chiefdelphi.com/forums/forumdisplay.php?f=173)
-   -   gyro problem (http://www.chiefdelphi.com/forums/showthread.php?t=81704)

EagleS!! 02-02-2010 08:34

gyro problem
 
We put our gyro to the analog breakout. And when we open the driver station, indicator of gyro always turns around. When we move the robot, the indicator doesn't show a specific place. Do you have the same problem? Or what can we do?

Alan Anderson 02-02-2010 10:48

Re: gyro problem
 
Check your wiring. Make sure the signal, power, and ground connections are going to the proper pins on input 1 of the Analog Breakout board. Make sure there is 12v power to the Analog Breakout, and that its green LED is lit.

Are you using C++? LabVIEW? Java?

EagleS!! 02-02-2010 12:23

Re: gyro problem
 
We are using LabVIEW

jhersh 03-02-2010 03:06

Re: gyro problem
 
Are you moving your robot when you start the code? That would throw off the calibration making is spin all the time. Also, if it just isn't hooked up, it would probably just sit there, depending on the noise on the input.


All times are GMT -5. The time now is 08:02.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright © Chief Delphi