Servos won't work
 

Hello,
We are a rookie team just learning LabVIEW. We have been able to get our robot moving, but we are having problem with servos. I am attaching a copy of our program. I have tried changing the configurations on the motor configurations page but nothing has worked. I've also tried changing the channels that the servos are connected to. I tried moving the servo controller up in our daisy chain but then our motors wouldn't work. I am pretty positive that our wiring is right, but I could be wrong. If someone could take a look at the program and maybe give me some suggestions to make sure that my wiring is correct I would be extremely grateful.
Thanks
Hampton

Re: Servos won't work
 

You may be get better (ie non FRC answers) if you ask this in the FTC forum.

Re: Servos won't work
 

did you also put the Jumpers on the PWM terminals that have servos>>>>
cause if not they wont work even if the program is correct

Re: Servos won't work
 

What jumpers? What do they look like? Where do I attach them? This is all new to me so I have no idea what you are talking about. I will also post this in the FTC forum. Thanks :)