crio dashboard GPIO output
 

How do you get the dashboard to should active GPIO output?

Re: crio dashboard GPIO output
 

We are having trouble getting our robot function at all. The speed controlers wont work and the signal light is going out when the robot is enabled. in short all the signal lights on the robot (jaguars,spikes, and sidecar) and the air compresser are going off at the same time. the driver station is saying watchdog not fed at the same time as the lights go out. I am out of ideas as to what the problem is.

Re: crio dashboard GPIO output
 

I got Mr. Rogers' email.

Are you sure you're using a fully charged battery?

Re: crio dashboard GPIO output
 

Yes, we were using a fully charged battery

Re: crio dashboard GPIO output
 

Sorry, that was addressed to that 2nd off-topic post.

To get the GPIO to show on your Dashboard you'll need to add the GPIO values into the Dashboard feed in your code on the cRIO.

What language are you using?

Re: crio dashboard GPIO output
 

Whoops, sorry about that. We're using java. How exactly do you add the GPIO values into the Dashboard feed?

Re: crio dashboard GPIO output
 

Check the Java examples for use of the Dashboard classes, such as, DashboardDataSender.

Re: crio dashboard GPIO output
 

Thanks for your time. I found how to do it in the manual xD last night.

Re: crio dashboard GPIO output
 

Yea, thank you very much. We used the default code you suggested and it worked. Thanks!