Chief Delphi - FIELD DRAWINGS

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Technical Discussion (http://www.chiefdelphi.com/forums/forumdisplay.php?f=22)

- - FIELD DRAWINGS (http://www.chiefdelphi.com/forums/showthread.php?t=83033)

tomy	18-02-2010 19:29

FIELD DRAWINGS

:mad: I am the programmer on our team and we would like accurate measurements of the field and we can not find anything.If there is another thread I'm sorry to post this. We got some measurements but not all. We are looking for the whole field we got the dots for the balls but what is the measurement from the alliance wall to the center of the bumper. We have been looking for a while and we need the measurements to START working on the autonomous mode. Please post quickly

EricH

18-02-2010 19:33

Re: FIELD DRAWINGS

The field drawings are in the same place as the Manual, listed under Section 6.

Michael Ogden

18-02-2010 19:33

Re: FIELD DRAWINGS

The measurements should be in the rule book. Keep in mind that at least one update has altered the measurements.

EricH

18-02-2010 19:43

Re: FIELD DRAWINGS

Quote:

Originally Posted by Michael Ogden (Post 923369)

The measurements should be in the rule book. Keep in mind that at least one update has altered the measurements.

Not quite. The measurement given is "approximately one-third of the length of the field". Keep in mind that the dimensions in the Manual are only meant to be approximations, and the official drawings take precedence over those per Update #3.

All times are GMT -5. The time now is 14:36.