![]() |
MMRambotics - 12.2 Second Bumper Change
Hi,
Here is a short clip of out bumper mount system, the bumpers are able to be changed in 12.2 seconds by four people. -Sean |
Re: MMRambotics - 12.2 Second Bumper Change
That's a sweet system.
I do hope that that isn't your finished robot. Bumper must be back by the robot frame per: M. The entire length of the BUMPER backing must be supported by the structure/frame of the ROBOT (i.e. the backing material must not be in “free space” between or beyond attachment points) (see Figure 8 – 3). A good hit, at the top of your bumpers, could seriously bend your mounts. |
Re: MMRambotics - 12.2 Second Bumper Change
the mounts are about 1/2 way up the bumper, and the entire length is supported by the frame.
|
Re: MMRambotics - 12.2 Second Bumper Change
Quote:
Although I agree that a hit at the top very well could damage the bumpers or frame. |
Re: MMRambotics - 12.2 Second Bumper Change
I'd be more concerned with the provision that bumpers must be securely mounted. I can't see the details of the system, but I'd expect an inspector to want some assurance that your bumpers aren't going to release when someone runs into you. If you leave a bumper on the field during a match, expect to receive extreme scrutiny from inspectors and an order that you make sure it can't happen again.
|
Re: MMRambotics - 12.2 Second Bumper Change
Quote:
|
Re: MMRambotics - 12.2 Second Bumper Change
The bumper system is very robust. Even a horizontal blow from below will not likely dislodge the bumper. The means by which the bumpers butt up against each other (45 degrees) creates a solid bumper "unit" with the bumper structures "supporting each other" as well as the frame.
|
Re: MMRambotics - 12.2 Second Bumper Change
Quote:
|
| All times are GMT -5. The time now is 20:42. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright © Chief Delphi