Chief Delphi - Andymark Hex Bearing Trouble

Page 2 of 2

Show 100 post(s) from this thread on one page

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Technical Discussion (http://www.chiefdelphi.com/forums/forumdisplay.php?f=22)

- - Andymark Hex Bearing Trouble (http://www.chiefdelphi.com/forums/showthread.php?t=84731)

joek	30-11-2010 18:35

Re: Andymark Hex Bearing Trouble

Quote:

Originally Posted by AdamHeard (Post 982739)

The outside diameter is the same of a Normal FR8 (1.125), The Flange thickness, Flange Diameter, and overall bearing thickness aren't posted.

thought you meant relative to the replaced bearing
flange thickness is .062, overall thickness: 0.312 inch

AdamHeard

30-11-2010 19:10

Re: Andymark Hex Bearing Trouble

Quote:

Originally Posted by joek (Post 982753)

thought you meant relative to the replaced bearing
flange thickness is .062, overall thickness: 0.312 inch

I see that its posted now. The first time I clicked Andy's link it took me to just a picture. Thanks!

Good to know it's identical to an FR8 in size.

Andy Baker

01-12-2010 09:12

Re: Andymark Hex Bearing Trouble

Quote:

Originally Posted by AdamHeard (Post 982762)

Good to know it's identical to an FR8 in size.

Don't cut metal yet. I just went to the shelf, grabbed a few, and measured the overall thickness and flange thickness.

The overall thickness is correct on the website, at 0.312". However, the flange thickness is a tad thinner than what we designed. It is 0.055". I see a minimum dimension of 0.054" and a maximum of 0.056". The website has been updated.

So, the outside geometry is a bit different from a regular FR8ZZ, as the flange thickness on this new bearing is 0.007" thinner.

Sincerely,
Andy Baker

All times are GMT -5. The time now is 09:17.

Page 2 of 2

Show 100 post(s) from this thread on one page