pic: Hart Robot 2010
 

Re: pic: Hart Robot 2010
 

That's actually pretty cool. How well did this work out for you and how were you raising and lowering the drive?

Re: pic: Hart Robot 2010
 

Are those rover wheels and vex omni wheels? How did you decide to use them?

Re: pic: Hart Robot 2010
 

This drive train worked very well because it prevented us from tipping over when going over the bump and also absorbed the shock of hitting the ground after climbing the bump at full speed. I sometimes sometimes it looked as if we actually were jumping over it.

We used pneumatics mounted on one end to the frame and the other end to the wheel module. It worked (at least mechanically) in a similar way to 177's drivetrain did.

We used the KOP part wheels from 2007 and screwed roughtop conveyor belting from mcmaster onto the surface for extra traction. The omni wheels are the 6in plastic Omni wheels from AndyMark. We used the center two wheels on side as traction wheels and the omnis were on the ends so that we could turn easier.

I can post pictures if you would like.

Re: pic: Hart Robot 2010
 

Any videos? :D

Re: pic: Hart Robot 2010
 

No Videos yet, my team will try to upload some to youtube soon.

If you want to see more pictures you can go to our website gallery at

Re: pic: Hart Robot 2010
 

No Videos yet my team will try to upload some to youtube soon.

Re: pic: Hart Robot 2010
 

As of now I have some videos but cannot upload them yet. So if anyone wants them ask and I can try emailing them.