Field Technicality
 

Hey, I know I should feel really stupid about asking this, but the manual seemed unclear about it.

How high is the sensor on the minibot pole above the base?

If there is a resource I could use to find this information, that would be great as well.

Thanks!:)

Re: Field Technicality
 

As stated under section 2.2.5, The bottom of the lower disk (i.e. the portion of the TARGET contacted by the climbing MINIBOT) is approximately 122 inches above the floor., and the circular base is 12 inches tall. Therefore, 122-12, meaning that there are 110 inches between the two. Correct? ::rtm::

Re: Field Technicality
 

The manual is quite clear. Section 2 gives the height as 122" above the floor.

You could also find the info in the field drawings.

Ctl-F is the typical way to access a PDF reader's "find" feature, which may help find these.

(CD's search feature is in the orange bar, if you suspect someone else has asked the same or a similar question.)

Re: Field Technicality
 

Thanks! That helps a lot! Didn't see that in the manual.