Is there a pre-built labView program for rookie teams?
 

Hello,
I went to a talk/seminar on LabView. The rep from NI mentioned there was a pre-built/default program that rookie teams can use. (It has a big "finish" button on the front panel). Did I misunderstand him or is this located somewhere? If so, where do I find it?

Thank you.

Re: Is there a pre-built labView program for rookie teams?
 

That's the default Framework that comes with the LabVIEW installation.

Start LabVIEW
Under "New" select FRC cRIO Robot Project
In the popup window give it a new name
Change the cRIO IP address to match your team number
Select Robot Framework
Select Finish

and you'll have your default project that does Arcade drive off one joystick and two motor controllers plugged into PWM 1 & 2.

Re: Is there a pre-built labView program for rookie teams?
 

I clicked on new....and saw several projects...however I do not see anything that says frc crio project....

Re: Is there a pre-built labView program for rookie teams?
 

This is the one I mean, where I've marked the screen in blue, click on that.

Re: Is there a pre-built labView program for rookie teams?
 

Your LabVIEW installation might not have fully succeeded, or you might not have run the required LabVIEW and Utilities updates. You know where to find the updates, right?

Re: Is there a pre-built labView program for rookie teams?
 

That option does not show up on my computer. Perhaps the software was not installed correctly.....is there a way to get this...or do I need to reinstall?

Re: Is there a pre-built labView program for rookie teams?
 

Did you apply the LabVIEW software update Alan refers to?
You do that after using the LabVIEW installation DVD.
Ther's a link in my signature where you can get it.

You can run the LabVIEW installer and update again and it's smart enough to add anything you might have missed.

Re: Is there a pre-built labView program for rookie teams?
 

http://usfirst.org/roboticsprograms/....aspx?id=18758

Click and it should give you the locations with the updates. I had the same issue and I had to redo everything so to avoid it, you must click on the URL and download the updates.

http://joule.ni.com/nidu/cds/view/p/id/2262

here is the link to one download

http://joule.ni.com/nidu/cds/view/p/id/2263

another one.

http://joule.ni.com/nidu/cds/view/p/id/2261

last one

extract and run the app.

Good luck and may the force be with you!!!

Re: Is there a pre-built labView program for rookie teams?
 

Here's what the LabVIEW startup screen looks like right off the Install disk, if you have NOT installed the required update.