Chief Delphi - Default NI robot control program?

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- General Forum (http://www.chiefdelphi.com/forums/forumdisplay.php?f=16)

- - Default NI robot control program? (http://www.chiefdelphi.com/forums/showthread.php?t=89298)

jgruber2713

16-01-2011 19:50

Default NI robot control program?

Hello, I understand there is default NI robot code provided within the KOP or NI software. i.e a basic driving / control program. I’m new to LabView programming. Can someone give me information on where to find it? :confused:

Mark McLeod

16-01-2011 20:08

Re: Default NI robot control program?

After the LabVIEW update has been installed you will see it as a choice on the LabVIEW startup window.

It's highlighted in this picture.

jgruber2713

16-01-2011 21:41

Re: Default NI robot control program?

Thanks Mark! I appreciate the info. Will pull down the update and install.

Best Regards,
Joe

All times are GMT -5. The time now is 21:15.