Chief Delphi - Victor Motor Controlers

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Electrical (http://www.chiefdelphi.com/forums/forumdisplay.php?f=53)

- - Victor Motor Controlers (http://www.chiefdelphi.com/forums/showthread.php?t=89705)

Victor Motor Controlers

How do you hook up the fan correctly on the victor?

Re: Victor Motor Controlers

Attach the two fan wires to the Power side of the speed controller, this allows the fans to run whenever the robot is turned on.

Quote:

<R55> The control system is designed to allow wireless control of the ROBOTS. The Driver Station
software, FirstTouch I/O module, cRIO-FRC, speed controllers, relay modules, radio, and
batteries shall not be tampered with, modified, or adjusted in any way (tampering includes
drilling, cutting, machining, gluing, rewiring, disassembling, etc.), with the following
exceptions:

D. The supplied fans attached to speed controllers may be powered from the power input
terminals.

Re: Victor Motor Controlers

IFI recommends that you attach the fan leads to the power input on the individual Victor. However, you may parallel all fans and connect to a single 20 circuit branch on the PD if you choose. Wiring directly to the power input has a great benefit. If the Victor is receiving power, then the fan is turning. You don't need to be able to see the LED on the Victor base.