pic: What is this?
 

Re: pic: What is this?
 

Is there any bearing material between the pieces of 80/20? Without that I foresee a lot of mechanical inefficiency in the system. Other than that it looks like you are doing a good job.

Re: pic: What is this?
 

An elevator made out of 80/20 and #25 run inside the 80/20 to raise/lower it?

Re: pic: What is this?
 

YES! We discovered that #35 chain fits almost perfectly between adjacent pieces of 8020. Add to that the fact that the steel-to-aluminum friction is very low, and you've got a very good thing.
We mounted two verticle pieces of 8020 to the drive train frame, and ran the chain down the slot to a "elevator car" that rides on two pieces of 8020 about 12" long. (There's about 1/16" gap between the car and the rails, so there's little side-to-side drag. ) The car is attached to the chain at the top and bottom, and the chain loops out the bottom via sprockets back to the top. Add a Barbie to drive the sprocket, and we've got a low friction high strength elevator!

Re: pic: What is this?
 

Were thinking of doing something extremely similar to this. As this is only are 2nd year would you mind answering a few questions.

What size/type 8020 did you use?

How do you mount the sprockets to the end of the 8020?

Thanks.

Re: pic: What is this?
 

Standard 1" x 1"; if you need the exact part number I can dig it up.

We bolted a piece of 3/8" lexan to the end of each 8020. The shaft for the sprocket goes through bearings which are mounted to the lexan. We used T-bolts to attach the lexan to the 8020, so we could slide the lexan (and therefore the shaft) to take up any chain slack.

Re: pic: What is this?
 

Interesting. Looks like things are coming along.

How 'bout a quick vacuum of the robot frame? :P

-Nick

Re: pic: What is this?
 

Good idea! My only warning is that we used 80/20 in the past to build a forklift (2008) and unless everything is 100% lined up, you're going to start building up a lot of friction. Given that we had quite a bit more on the end of the forklift though which contributed to the problem, I'd still watch out for friction, it's a killer.

Re: pic: What is this?
 

Your saving grace here is that the aluminum used for in 8020 is anodized. The anodized layer is very hard and wear resistant. Without this layer the aluminum would quickly gall and cause an immense amount of friction. I would definitely keep those slots greased or oiled in case the anodized layer starts to scrape off!

Re: pic: What is this?
 

Another question. Do you have a chain on each side of the lift, and if so are both sides powered or does one side just free slide?

Re: pic: What is this?
 

What motor are you planning to use. My team is planning to use either a fisher price or window for our motor, and we can't decide.