Chief Delphi
Page 2 of 2 < 1 2
Show 100 post(s) from this thread on one page

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)
-   FRC Control System (http://www.chiefdelphi.com/forums/forumdisplay.php?f=176)
-   -   Incorrect voltage readout on Driver Station (http://www.chiefdelphi.com/forums/showthread.php?t=91024)

wireties 22-02-2011 01:16
Re: Incorrect voltage readout on Driver Station
 
Quote:
Originally Posted by Alan Anderson (Post 1028862)
The problem became obvious once I realized what to look for.

Keith, your NI 9201 module is in Slot 8 of the cRIO chassis. It needs to be in Slot 1, at the end nearest the Ethernet ports and power connector.

Hmmm - I'll check it tomorrow. I thought it was in slot 1.

Thanks

wireties 22-02-2011 17:50
Re: Incorrect voltage readout on Driver Station
 
Quote:
Originally Posted by Alan Anderson (Post 1028862)
The problem became obvious once I realized what to look for.

Keith, your NI 9201 module is in Slot 8 of the cRIO chassis. It needs to be in Slot 1, at the end nearest the Ethernet ports and power connector.
Thanks Alan - the students swapped the cRio mount around and I did not even notice - an acute case of cRio slot dyslexia!!

All is good now!


All times are GMT -5. The time now is 16:47.
Page 2 of 2 < 1 2
Show 100 post(s) from this thread on one page

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright © Chief Delphi