Chief Delphi

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)
-   General Forum (http://www.chiefdelphi.com/forums/forumdisplay.php?f=16)
-   -   Solenoid slot on Crio question (http://www.chiefdelphi.com/forums/showthread.php?t=91314)

takiko1996 08-02-2011 23:24
Solenoid slot on Crio question
 
How many of the NI 9472 blocks on the Crio can we use this year?

Mark McLeod 08-02-2011 23:29
Re: Solenoid slot on Crio question
 
Two, using slots 7 & 8.
Only one can be 24v, so you can have:
  • (1) 24v and (1) 12v solenoid module
or
  • (2) 12v solenoid modules

takiko1996 08-02-2011 23:35
Re: Solenoid slot on Crio question
 
Thank you :)

Mark McLeod 08-02-2011 23:43
Re: Solenoid slot on Crio question
 
Planning on lots of solenoids and/or line tracking sensors? :)

takiko1996 09-02-2011 00:51
Re: Solenoid slot on Crio question
 
I believe so :D and where can i verify about the amount of solenoid slots?

Al Skierkiewicz 09-02-2011 08:27
Re: Solenoid slot on Crio question
 
Taiko,
Two slots will give you 16 individual solenoid outputs.

Mark McLeod 09-02-2011 09:52
Re: Solenoid slot on Crio question
 
That translates to 8 double solenoids or 16 single solenoids.

If you need even more, then Relay/Spikes can be used to get you up to 16 more.


All times are GMT -5. The time now is 09:53.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright © Chief Delphi