Invert Motor Not Honored
 

It could simply be me, but..

When using OPEN 4 Motor Can Jaguar, it appears that the Boolean to Invert either the right or left motors is not being honored correctly.

I push the joystick forward and it runs backwards for both left and right.

I've tried a number of permutations and the results are always the same.
I've checked my electrical and can wiring. I do have both FRONT and REAR motors on each side connected their appropriate Boolean.

Has any one else experienced this? I'm stumped.

Re: Invert Motor Not Honored
 

Well I am at a loss to explain it... However, it appears to working normally now.
There have been too many changes since I experienced this

Labview Update 3.2, CRIO Image V28. A complete new project.

Apparently, it's a red herring as I'm at a loss.

Re: Invert Motor Not Honored
 

it's hard telling really. We've been having weird issues that just don't make sense. It's just the joys of programming I guess.