Differn't Cypress I/O usage
 

Is it possible to use a different Cypress I/O module than the one supplied in the kit of parts. I messed up and ordered the PSOC 5 board (same layout except black instead of blue) and our computer will see it but we can not load the First program on to it.

One I ordered
http://www.cypress.com/?rID=43674

One that comes with the KOP
http://www.cypress.com/?rID=38235

Thanks,

Re: Differn't Cypress I/O usage
 

I don't think the rules prohibit it, but that doesn't mean it will work with the DS as a drop-in replacement.

I'd think your options are to see if they will swap for the correct one, or see if you can program it using the hex file. I suspect the hex for one model will not work for the others. If you do get it to work, please post how.

Greg McKaskle

Re: Differn't Cypress I/O usage
 

You would have to recompile the FIRST source for the new target.


There was a thread where other people mentioned having the same problem.

Re: Differn't Cypress I/O usage
 

I downloaded the source but get this error when I try to open either the workspace or project file:

Error: prj.M0052: Unable to open the project "": (Unexpected xml node type encountered: Element, expected: EndElement). Address the error and try again.


I tried downloading a new copy, but the same thing happens. Ideas?

Re: Differn't Cypress I/O usage
 

I looked at the source code and the PSOC programmer. I think I can use the PSOC 5 but I will lose some functionality. I was able to compile it and download it to the PSOC though.

Re: Differn't Cypress I/O usage
 

I should add the only thing I did was update the psoc creator and change the device by project>> device selector

Re: Differn't Cypress I/O usage
 

Solved my own problem - just had to update the Cypress software.