Chief Delphi - Using a 3 volt gyro

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- NI LabVIEW (http://www.chiefdelphi.com/forums/forumdisplay.php?f=182)

- - Using a 3 volt gyro (http://www.chiefdelphi.com/forums/showthread.php?t=91855)

kgzak

14-02-2011 21:58

Using a 3 volt gyro

we bought a gyro but the input is only 3 volt. We are not to worried about the input but the fact that the standard voltage is 1.35. How do we read this in Labview?

Thanks

Joe Ross

14-02-2011 22:04

Re: Using a 3 volt gyro

In the gyro open, it measures the average voltage for a period of time (I think I remember 2 seconds). It uses that as the no rotation value. Using a 3 volt gyro should not be a problem for that.

kgzak

14-02-2011 23:13

Re: Using a 3 volt gyro

Quote:

Originally Posted by Joe Ross (Post 1023161)

In the gyro open, it measures the average voltage for a period of time (I think I remember 2 seconds). It uses that as the no rotation value. Using a 3 volt gyro should not be a problem for that.

ok. cool. I was worried that it based it on the standard 2.5 volt that the kit encoder uses.

All times are GMT -5. The time now is 09:18.