Re: How do we get the spike in both directions in labview?
 

ok..

thank you.

i installed the drive station update and the labview 3.2 update.
now when i deploy the code , show the message "Failed to conect the Real Time target"

do you know what i can make, can you help me?

thank you

Re: How do we get the spike in both directions in labview?
 

HELP me

what is this message "Failed to conect the Real Time target" ??

Re: How do we get the spike in both directions in labview?
 

It simply means communication between the cRio and the PC is down. Try resetting the cRio. Also check your IP addresses. Another issue may be that you may need to reimage your cRio if the firmware has been updated.

Re: How do we get the spike in both directions in labview?
 

THANK YOU VERY MUCH!!

Now my robot is running!!!

THANK YOU..

Re: How do we get the spike in both directions in labview?
 

So, what did you do exactly?

Re: How do we get the spike in both directions in labview?
 

hii,

i reimage the crio after the drive station update and the labview update.

and i modified the solenoid, run the program and the code is running!!