Recovering a bricked Crio?
 

When we were upgrading to V28, our Crio quit responding.

It started to update, then froze at the "rebooting Crio". Now the imaging utility does not see the CRio. The Status LED blinks once (indicating the CRIO is not configured). I couldn't even get it to boot in safe mode. Also tried to reset the IP address and any other combination of jumpers that I thought would be useful, and it did nothing.
Also tried using the MAX explorer, which couldn't find it either.

Its possible that I had tried to flash a C++ version as a Labview version, but I haven't confirmed this yet.

Anyone have this problem? Any way to recover it?

Re: Recovering a bricked Crio?
 

Do you have a null modem cable? Try setting IP Reset and Safemode. Set your pc to 10.0.0.100 and subnet 255.0.0.0. Then use Mesurement and Automation Explorer to format it and assign an ip.