Chief Delphi - Tetrix Bearing Size

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Motors (http://www.chiefdelphi.com/forums/forumdisplay.php?f=52)

- - Tetrix Bearing Size (http://www.chiefdelphi.com/forums/showthread.php?t=93667)

team63

16-03-2011 08:18

Tetrix Bearing Size

Does any one know the OD and ID of the Tetrix Pivot Bearings?

Bruceb

16-03-2011 08:59

Re: Tetrix Bearing Size

If you are talking about the bronze bushings I believe they are 3/16 id and 5/16 od.
Bruce

rees2001

16-03-2011 09:37

Re: Tetrix Bearing Size

The OD is .315", the id is .115".

good luck

IKE	16-03-2011 09:54

Re: Tetrix Bearing Size

Quote:

Originally Posted by rees2001 (Post 1040601)

The OD is .315", the id is .115".

good luck

Assuming you are talking about the servo bearing.

id is 3mm
OD is 8mm

It is about 3mm wide. It comes with a screw, nut and a couple of washers.

rees2001

16-03-2011 20:45

Re: Tetrix Bearing Size

Quote:

Originally Posted by IKE (Post 1040612)

Assuming you are talking about the servo bearing.

id is 3mm
OD is 8mm

It is about 3mm wide. It comes with a screw, nut and a couple of washers.

Yep, the servo bearing. I just checked it quick with a set of calipers. I tried a 3mm screw but it didn't fit in the one I checked.

All times are GMT -5. The time now is 04:48.