Chief Delphi - Use/Conversion of Cypress Output Values

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- NI LabVIEW (http://www.chiefdelphi.com/forums/forumdisplay.php?f=182)

- - Use/Conversion of Cypress Output Values (http://www.chiefdelphi.com/forums/showthread.php?t=98374)

Re: Use/Conversion of Cypress Output Values

You need to make any and all controls changes the permanent default by clicking on:

Edit -> Make Current Values Default

You can also click on individual controls and make just one or a couple change, instead of all of them.

That's so you can play all you want with the controls, but you won't destroy the original settings until you really want to.

Re: Use/Conversion of Cypress Output Values

Quote:

Originally Posted by kws4000 (Post 1088891)

Okay, now I have a realitively big issue that is not stopping me any, but may be an issue in the future.

In the Teleop VI, with the Set Enhanced Digital Config VI, with the Enum Cluster pulled out as a control to the Front Panel of the Teleop VI, the values continioulsy reset:eek: after I close the Teleop VI after I am done with it.

Is this an error with LV, or something hardwired in the Set Config VI that I don't want to mess around with?:confused:

If I understand you correctly, that's a problem with the default value of the cluster. Set the cluster to have the values you want it to retain, then right click on it and under Data Operations, choose Make Current Value Default. LV should then retain that data for the cluster.
Attachment 11155

Re: Use/Conversion of Cypress Output Values

And my Qs are A'ed.

Thanks, sanity has (almost) been restored!:D

If only there was such a clear-cut answer for game hints.....:confused: