pic: FTC290 2011-2012 Mast
 

Re: pic: FTC290 2011-2012 Mast
 

I applaud the height, but...

Have you measured where the system's center of gravity resides once the mast is extended (the system includes the two crates).

I suspect that an incidental bump from another robot or a bowling ball has a good chance of tipping the entire system onto its side. That would be a bad thing during a match.

Re: pic: FTC290 2011-2012 Mast
 

Our team took the risk. The strategy was to lift the mast while you are in the safe zone and having the other arm all the way down to try and prevent that from happening.

Re: pic: FTC290 2011-2012 Mast
 

Thats impressive. Any video of it driving around with the mast all the way up?

Re: pic: FTC290 2011-2012 Mast
 

I wouldn't be too worried about the stability, as long as you don't move with the mast extended.

Good strategy.

Re: pic: FTC290 2011-2012 Mast
 

I don't think it would be too hard to attach some passive stablizers which flip out when the arm extends up. That would probably help a lot if your concerned with tipping and don't plan to move after raising the arm.

Very Cool, this is the highest I have seen a robot extend so far.

Re: pic: FTC290 2011-2012 Mast
 

Nothing except the videos of prototyping, once I get some good footage I will be sure to post it.

This bot isn't competing in any other events this year. 290's qualifier was last Saturday, which they made to the semifinals, but were unable to advance to states.

Re: pic: FTC290 2011-2012 Mast
 

Great job guys! Can 987's mentored team borrow it???:D But seriously...I would love to see a close up of your elevator/slide mechanism.

Re: pic: FTC290 2011-2012 Mast
 

How long does it take to reach full height?

Re: pic: FTC290 2011-2012 Mast
 

Well, the mast is attached to an arm that will pick up the crates from behind the bot, and then you have to line it up before you drive the mast. I'd say it takes about 10-15 seconds to do all of this, and get the mast to full height.