Chief Delphi

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)
-   Extra Discussion (http://www.chiefdelphi.com/forums/forumdisplay.php?f=68)
-   -   pic: 816's 2011 Off-Season Teaser (http://www.chiefdelphi.com/forums/showthread.php?t=98808)

thefro526 31-12-2011 19:16

Re: pic: 816's 2011 Off-Season Teaser
 
Quote:

Originally Posted by Brandon Holley (Post 1094860)
So are the center 6 wheels all on the same plane?

Correct, the center 6 Wheels are 1/8" lower than the outer pairs.

thefro526 05-01-2012 14:56

Re: pic: 816's 2011 Off-Season Teaser
 
Quote:

Originally Posted by Cory (Post 1090938)
I can tell you from our experience that would likely be a problem and require it to be broached multiple times, or from both sides (with a standard push broach). It's going to take a LOT of force too, since you have so much tooth engagement.

Just wanted to Follow up on Cory's post in case someone stumbles onto this thread in the future.

Each part, especially the hubs, did need to be broached multiple times. We've found that most Aluminum Hex runs a few thousandths over, which was enough to make assembly a PITA. If I counted correctly, each sprocket has now had the broach pressed through it three times, once to do the primary cut, two more (each from a different side) to open the hex up enough that it plays well with hex shaft. The wheels each took between 3 and 4 passes a piece before they played nice, again alternating sides with each pass.

With any luck, this should be running tonight.

Brandon Holley 05-01-2012 15:16

Re: pic: 816's 2011 Off-Season Teaser
 
Quote:

Originally Posted by thefro526 (Post 1096897)
With any luck, this should be running tonight.

Come back with vids.


All times are GMT -5. The time now is 22:32.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright © Chief Delphi