|
SOLUTION
Hey, i was able to get around this problem by following this procedure:
1) Turn OFF power to the cRIO
2) Turn the safe mode switch on the cRIO to the ON position.
3) Turn ON power to the cRIO
4) Open the cRIO imaging tool
5) Check the reformat checkbox in the imaging tool
6) Press the Apply button in the imaging tool
7) When the imaging tool pops up a dialog box stating that the cRIO is in safemode, press the button that allows it to continue reformatting
8) It should complete the imaging succesfully
9) Turn OFF power to the cRIO
10) Turn the safe mode switch on the cRIO to the OFF position
11) Turn ON power to the cRIO
12) In the imaging tool, Select the language you want to use (java/c++/labview), re-enter your device name, re-enter your team number
13) Select apply in the imaging tool
14) The cRIO should now successfully re-image.
I think at this point you will NOT have the CAN driver installed. I have not gotten to adding the can driver yet :-)
|