[mbone206]

Hi All,

After many hours yesterday, I decided to post these questions, will appreciate any support

I followed the ‘How to set up 2011 ‘driver station’ and I believed classmate imaged OK.
This is a 2010 classmate, so I skipped next two steps: Initial driver Station and Set Up Wizard
Next step: Windows 7 Activation, Ran Classmate_update.bat, I believe it ran OK
Next step: Update Classmate Software: This did not make much sense. The link in documentation was to 2010 upgrades, so I ignored it. At this point, I found three 2011 upgrades: LABview, Utilities, driver station (these worked after installing kit DVD on home lap top)

Problems on classmate:
Every time boot up, Windows does following:
• when turn on: Configure windows update, 0% -- runs few minutes
• then displays failing updates: Reverting
• when complete, have 3 log in icons: driver, developer, team

Is there a problem with Windows upgrade, why does this haapen?

Is LABView 8.6 on classmate, I logged into developer to install above upgrade files, but I do not see LABView? I guess I can not develop on classmate (but whio cab see on that screen anyway), I do have dash board & driver station. Do I just run Driver Station upgrade mentioned above? What about Utility upgrade?

Also, how do I know everything is installed correctly with proper revision?

Appreciate your support