Thread: FRC 2011 cRio
View Single Post
  #5   Spotlight this post!  
Unread 16-01-2011, 19:45
kennethdharmon2 kennethdharmon2 is offline
Registered User
FRC #1288
  
Join Date: Jan 2011
Location: St. Charles, MO
Posts: 18
kennethdharmon2 is an unknown quantity at this point
Re: FRC 2011 cRio
TD912, I'm curious, what type of errors were you seeing?

There was this comment in the "Getting_Started_with_the_2011_FRC_Control_System_ Rev_A.pdf"
"If you currently have National Instruments software on your PC, it will not interfere with that installation. However it will install over another version of LabView 8.6."

This led us to believe you didn't need to do an uninstall of LV 8.6, 2010, before installing the 2011 version. So we installed 2011 LabView right over the 2010 version, works fine, can deploy code, but can't seem to successfully set it as startup code. Not sure why. Did you see this issue?